Collapsible content

What is the Wh of the Kicker & Cruiser?

Although the battery is quoted as 18.5V and 14.4Ah which would give 266Wh, the certification means that the actual Wh is based on 18V ~ 259Wh.

What is the running time of the motor on maximum?

Although the motor is quoted as 1000W watts, to ensure a more usable running time and meet the EU lake restrictions of 800W, the motor has been derated to 720W.

As such, the estimated running time on maximum is 20 minutes.

What is the motor wattage?

Although the motor is quoted as 1000W watts, to ensure a more usable running time and meet the EU lake restrictions of 800W, the motor has been derated to 720W.

Why is the battery & charger not matched?

The standard charger is quoted as 4 hours and 12V 5amp, where as the battery is 18.5V (3.7V x 5S).

The reason for this is because the factory technicians advised to use 5S for the motor controller.

For the next generation it will be 6S (22,2) and the 5HP will be 36V or 48V.

Is there a boost controller built in to the Kicker and Cruiser to take 12v input up to 21v for charging?

The motor uses a BMS system that can work between 12V and 24V because it goes past the battery and thru the PCM/BMS card.

How long does it take to charge with the fast charger?

The fast charger will charge the battery in 2 hours.

What amperage is the fast charger?

10A

What voltage does the fast charger put out?

21V

What wattage does the fast charger put out?

200W

What should I do if the propeller is stuck or jams?

Remove the kill cord and remove the obstacle until the propeller rotates freely. Do not repeatedly try to run the motor as this may cause damage to the motor and
potentially overheat.

Can I use Thrustme in salt water?

Yes, but please remember to always rinse your motor in fresh water after use in salt water to prevent salt corrosion when stored.